Table of Contents
Advertisement
Chapter 7
Configuring Switch-Based Authentication
Because this command is session-oriented, it must be accompanied by one or more of the session
identification attributes described in the
cannot be located, the switch returns a CoA-NAK message with the "Session Context Not Found"
error-code attribute. If the session is located, the switch disables the hosting port and returns a CoA-ACK
message.
If the switch fails before returning a CoA-ACK to the client, the process is repeated on the new active
switch when the request is re-sent from the client. If the switch fails after returning a CoA-ACK message
to the client but before the operation has completed, the operation is restarted on the new active switch.
A Disconnect-Request failure following command re-sending could be the result of either a successful
Note
session termination before change-over (if the Disconnect-ACK was not sent) or a session termination
by other means (for example, a link failure) that occurred after the original command was issued and
before the standby switch became active.
CoA Request: Bounce-Port
This command is carried in a standard CoA-Request message that contains the following new VSA:
Cisco:Avpair="subscriber:command=bounce-host-port"
Because this command is session-oriented, it must be accompanied by one or more of the session
identification attributes described in the
cannot be located, the switch returns a CoA-NAK message with the "Session Context Not Found"
error-code attribute. If the session is located, the switch disables the hosting port for a period of 10
seconds, re-enables it (port-bounce), and returns a CoA-ACK.
If the switch fails before returning a CoA-ACK to the client, the process is repeated on the new active
switch when the request is re-sent from the client. If the switch fails after returning a CoA-ACK message
to the client but before the operation has completed, the operation is re-started on the new active switch.
Stacking Guidelines for Session Termination
No special handling is required for CoA Disconnect-Request messages in a switch stack.
Stacking Guidelines for CoA-Request Bounce-Port
Because the bounce-port command is targeted at a session, not a port, if the session is not found, the
command cannot be executed.
When the Auth Manager command handler on the stack master receives a valid bounce-port command,
it checkpoints the following information before returning a CoA-ACK message:
•
•
The switch initiates a port-bounce (disables the port for 10 seconds, then re-enables it).
If the port-bounce is successful, the signal that triggered the port-bounce is removed from the standby
stack master.
If the stack master fails before the port-bounce completes, a port-bounce is initiated after stack master
change-over based on the original command (which is subsequently removed).
If the stack master fails before sending a CoA-ACK message, the new stack master treats the re-sent
command as a new command.
OL-12247-04
the need for a port-bounce
the port-id (found in the local session context)
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
"Session Identification" section on page
"Session Identification" section on page
Controlling Switch Access with RADIUS
7-22. If the session
7-22. If the session
7-25
Advertisement
Chapters
Table of Contents
Troubleshooting
