Phone Setup; Phone Hardware Installation; Install The Phone Battery - Cisco 8821 User Manual
Hide thumbs
Also See for 8821:
- Manual (202 pages) ,
- Administration manual (158 pages) ,
- User manual (106 pages)
Table of Contents
Advertisement
Phone Setup
•
•
Phone Hardware Installation
Before you can use your phone, you must install and charge the battery. The battery may already be installed
in your phone, or you may have to install it yourself.
You must read the safety information in
charge the phone.
The battery may already be charged using one of the supported charging methods. If the battery isn't charged,
you must charge the battery before you can set up the phone.
Install the Phone Battery
IP67 compliance means that the phone is sealed from dust and water. When the phone leaves the factory, it
is completely sealed.
If you need to open the battery compartment, don't open it in a dusty or wet environment.
You should make sure that the battery cover is closed to ensure that dust and water cannot enter the battery
compartment.
Note
Dirt, oil, or other products can damage the gasket on the battery compartment cover, resulting in a poor
seal. Every time you change the battery, inspect the gasket for damage. If the gasket is damaged, you can
order a replacement cover.
Phone Hardware Installation, page 17
Phone Configuration, page 27
C H A P T E R
Product Safety and Security, on page 95
Cisco Wireless IP Phone 8821 and 8821-EX User Guide
2
before you use, install, or
17
- Quick Links:
- Turn on Your Phone
- Unlock the Phone Keypad
Hide quick links:
Advertisement
Table of Contents
