Table of Contents
Advertisement
Chapter 2
Switch Installation
Table- or Shelf-Mounting
Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach the four rubber feet
to the recessed areas on the bottom of the chassis.
Remove two Phillips truss-head screws from the switch side panels and use those screws to attach the
brackets to the switch
hardware.
Do not use the 19-inch brackets to wall-mount the switch. The brackets are not suitable for
Caution
wall-mounting.
Figure 2-5
1
When you complete the switch installation, see the
for more information switch configuration.
After Installing the Switch
You might need to:
•
•
•
OL18479-01
(Figure
Attaching the 19-inch Brackets for Table- or Shelf-Mounting
User-supplied screws
Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
Use the CLI setup program to enter the initial switch configuration. See
the Switch with the CLI-Based Setup Program."
Connect to the front-panel ports. See the
on page 2-12
and the
"Connecting Devices to the Ethernet Ports" section on page
2-5). Secure the brackets to the table or shelf with the appropriate
AC OK
PS OK
100 -240
V ~
1.0- 5A
50-6 0 HZ
2
Phillips truss-head screws
"After Installing the Switch" section on page 2-11
"Installing Devices in 10-Gigabit Ethernet Slots" section
Catalyst 2350 Switch Hardware Installation Guide
Installing the Switch
1
2
Appendix C, "Configuring
2-16.
2-11
Hide quick links:
Advertisement
Table of Contents
