Ac Power Connection Information; Safety Information; Warning: Installation Of The Equipment Must Comply With Local And National Electrical Codes. Statement - Cisco 1120 Hardware Installation

Connected grid router

Hide thumbs Also See for 1120:

Installation manual (164 pages)

Quick start manual (10 pages)

Manual (6 pages)

Table of Contents

Safety Information

When connecting the router to AC power, you must ensure that the following conditions are met:



AC power is available at the installation location.



AC power can be readily and conveniently removed from the router. The power should not be removed by

disconnecting the AC power connector on the unit.

Warning:

The plug-socket combination must be accessible at all times, because it serves as the main disconnecting

device. Statement 1019

Warning:

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Warning:

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Warning:

Before connecting or disconnecting the power cord, you must remove AC power from the power cord

using a suitable service disconnect.



When you install the unit outdoors, or in a wet or damp location, the AC branch circuit that powers the unit should

have ground fault protection (GFCI), as required by Article 210 of the NEC.



Ensure that the user-supplied AC power plug is certified for outdoor use and has a minimum rating, such as

Interpower 84131251 or Hubbell HBL316P6W (IEC/EN60309 pin-and-sleeve type connectors).



If the power cord goes through a metal cover, a bushing should be installed to prevent fraying of the cord. When

using a strain relief bushing, follow these recommendations:

—

Use properly sized parts that are suitable for outdoor installation

—

Use bushings that are safety certified