Table of Contents
Advertisement
Rebooting the Switch
Example:
switch# configure terminal
switch(config)#
Step 2
Specify the slot number for the module that you are resetting by entering the reload module slot_numbercommand.
Example:
switch(config)# reload module 1
Rebooting the Switch
To reboot or reload the switch, use the reload command without any options. When you use this command,
you reboot the switch.
If you need to use the reload command, be sure to save the running configuration by using the copy
Note
running-config startup-config vdc-all command beforehand.
Step 1
Start the configuration mode by entering the configure terminal command.
Example:
switch# configure terminal
switch(config)#
Step 2
Save the running configuration by entering the copy running-config startup-config vdc-all command.
Example:
switch(config)# copy running-config startup-config vdc-all
Step 3
Reload the switch by entering the reload command.
Example:
switch(config)# reload
Overview of Supervisor Modules
The Cisco Nexus 7702 switch has one Supervisor 2 Enhanced (N77-SUP2E) supervisor module.
Cisco Nexus 7702 Hardware Installation Guide
48
Managing the Switch
Advertisement
Chapters
Table of Contents
