Cisco Catalyst 3850 series Configuration Manual page 316
Ip multicast routing configuration guide
Hide thumbs
Also See for Catalyst 3850 series:
- Configuration manual (58 pages) ,
- Hardware installation manual (146 pages)
Table of Contents
Advertisement
Configuring Basic IP Multicast Routing
Command or Action
Step 5
ip pim {dense-mode | sparse-mode |
sparse-dense-mode}
Example:
Device(config-if)# ip pim
sparse-dense-mode
Step 6
end
Example:
Device(config-if)# end
Step 7
show running-config
Example:
Device# show running-config
Step 8
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Related Topics
Prerequisites for Configuring SSM, on page 259
Configuring Static SSM Mapping(CLI), on page 270
Verifying SSM Mapping Configuration and Operation, on page 276
Static SSM Mapping, on page 265
SSM Mapping Overview, on page 264
Configuring DNS-Based SSM Mapping(CLI), on page 271
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
292
Purpose
VLAN, the IGMP static group, and physical interface. For a configuration
example, see
Example: Interface Configuration as an SVI, on page 96
These interfaces must have IP addresses assigned to them.
Enables a PIM mode on the interface.
By default, no mode is configured.
The keywords have these meanings:
• dense-mode—Enables dense mode of operation.
• sparse-mode—Enables sparse mode of operation. If you configure sparse
mode, you must also configure an RP.
• sparse-dense-mode—Causes the interface to be treated in the mode in
which the group belongs. Sparse-dense mode is the recommended setting.
Note
To disable PIM on an interface, use the no ip pim interface
configuration command.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Configuring Basic IP Multicast Routing
OL-32598-01
- Quick Links:
- Prerequisites for Using the Web Gui
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
