Table of Contents
Advertisement
6
PROGRAMMING
6.2
For Use in Normal System Configuration
(1) System configuration
(2) Conditions for the intelligent function module switch setting
Input range setting
CH1
CH2
CH3
to
CH6
(3) Program conditions
6
- 2
6.2 For Use in Normal System Configuration
QX10 (X/Y10 to X/Y1F)
Q66DA-G
(X/Y0 to X/YF)
HOLD/CLEAR function setting
4 to 20mA
0 to 5V
not used
(a) CH1 uses the rate control function (Refer to Section 3.2.4.)
• CH1 Increase digital limit value: 100
• CH1 Decrease digital limit value: 30
(b) CH2 uses the warning output function (Refer to Section 3.2.4.)
• CH2 Warning output upper limit value: 10000
• CH2 Warning output lower limit value: 3000
If a warning is output, the status of Warning output flag (Un\G48) is read and pro-
cessing for the warning output is performed.
(c) If an error occurs in writing a digital value, an error code is displayed in binary
coded decimal (BCD) form.
Error code shall be reset after removing of the cause.
QY10 (X/Y20 to X/Y2F)
CH1: 4 to 20mA output
CH2: 0 to 5V output
Normal resolution mode/ High resolution mode
CLEAR
-
High resolution mode
-
- Quick Links:
- I/O Conversion Characteristics
Hide quick links:
Advertisement
Table of Contents
