Table of Contents
Advertisement
7
ONLINE MODULE CHANGE
7
7.3 Online Module Change Procedure
- 22
7.3.4 When user range setting is used and initial setting was made with GX Configurator-DA (other system
(b) Click the "Execution" button to enable a module change.
If the following error message appears, the user range data cannot be saved.
Click the [OK] button, and perform the operation in This Section (2) (c) and later.
(c) After confirming that the "RUN" LED of the module has turned off, remove the
connector and dismount the module.
Always perform the dismounting procedure. If mounting confirmation is made
without the module being dismounted, the module will not start properly and the
"RUN" LED will not be lit.
- Quick Links:
- I/O Conversion Characteristics
Hide quick links:
Advertisement
Table of Contents
