Cisco Asr 1013 Router Slot Numbering; Installation Methods - Cisco ASR 1013 Hardware Installation Manual
Asr 1000 series
Hide thumbs
Also See for ASR 1013:
- Installation manual (42 pages) ,
- Quick start manual (37 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Cisco ASR 1013 Router Overview and Installation
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
Warning
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Before you install, operate, or service the system, read the Regulatory Compliance and Safety Information
Warning
for Cisco ASR 1000 Series Aggregation Services Routers publication. This document provides important
safety information you should know before working with the system. Statement 200
You have already unpacked your chassis and read all the site requirements for your new equipment.
Note
Proceed with the installation.
Cisco ASR 1013 Router Slot Numbering
The Cisco ASR 1013 chassis has two Cisco ASR100-RP2 (R0, R1) slots, two embedded services processor
slots (F0, F1) and six dedicated Cisco ASR1000-SIP slots (from bottom of chassis up, 0, 1, 2, 3, 4, 5
respectively).
The Cisco ASR 1013 Router is designed with each slot numbered as shown in the "Cisco ASR 1013
Router—Rear View" figure in the Rear View section.
Cisco ASR 1013 slots are keyed using rotated guide pins for the plug-in card to be fully inserted in slots
Note
where they are intended to operate. This keyed feature prevents cards from being inserted into the wrong
slots.
The Cisco ASR 1013 Router contains three SPA Interface Processor (SIPs) slots and supports four subslots
for the installation of SPAs. The following shows the Cisco ASR 1013 Router SPA subslot location.
Figure 179: Cisco ASR 1013 Router — ASR1000-SIP Subslots
Installation Methods
One set of forward rack-mount brackets come pre-installed on the Cisco ASR 1013 Router as shown in the
"Cisco ASR 1013 Router—Rear View" figure in the Rear View section, callout number 2. The accessory kit
contains the rear rack-mount brackets as shown in the "Cisco ASR 1013 Router—Rear View" figure in the
Rear View section, callout number 4, which are optional and another set of forward rack-mount brackets.
Cisco ASR 1000 Series Router Hardware Installation Guide
Installation Methods
371
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
