Connecting The Shared Port Adapter Cables - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Connecting the Shared Port Adapter Cables

The following image shows how to attach a grounding lug to the chassis ground connector.

Figure 213: Attaching a Grounding Lug to the Chassis Ground Connector

Locate the chassis ground connector on the side of your chassis.

Insert the two screws through the holes in the grounding lug.

Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the chassis.

Do not overtighten the screws.

Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate

chassis ground.

What to Do Next

This completes the procedure for attaching a chassis ground connection.

The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1001 Router

are contained in the respective configuration documents for each port adapter. For example, if you are

connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port Adapter

Installation and Configuration at the following location:

http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/

pa-pos-oc3_install_config/paposoc3.html

Cisco ASR 1000 Series Router Hardware Installation Guide

Chassis ground lead wire

Grounding stud

Cisco ASR 1001 Router Overview and Installation

Ground screws

Chassis ground connector

Show Quick Links

Table of Contents