Cisco ASR 1013 Hardware Installation Manual page 492

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Installing DC Input Power on the Cisco ASR 1001 Router

Secure the wires coming in from the terminal block plug so that they cannot be disturbed by casual contact.

Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block plug by casual

contact. Make sure the tie wrap allows for some slack in the ground wire. The following figure shows the DC terminal

block plug inserted and the tie wrap secured.

Figure 226: Complete DC Terminal Block Plug Insertion and Secure Tie Wrap

Ensure that the terminal block plug is fully seated in the terminal block header on the DC power supply panel. You will

hear a snap or click when installed properly.

Remove the tape (if any) from the circuit breaker switch handle, and move the circuit breaker switch handle to the On

At the rear of the router, place the power supply Standby switch in the On position to turn on the router.

The power supply LEDs light up when power is supplied to the router.

What to Do Next

This completes the procedure for connecting the DC power supply in the Cisco ASR 1001 Router.

Cisco ASR 1000 Series Router Hardware Installation Guide

DC power supply negative

(-) lead wire

DC power supply positive

(+) lead wire

Lead wires secured with a

Cisco ASR 1001 Router Overview and Installation

DC power supply ground

DC power supply terminal

block plug being inserted

into terminal block header.

Show Quick Links

Table of Contents

Troubleshooting