Removing A Shared Port Adapter From A Sip - Cisco ASR 1013 Hardware Installation Manual
Asr 1000 series
Hide thumbs
Also See for ASR 1013:
- Installation manual (42 pages) ,
- Quick start manual (37 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
DETAILED STEPS
Step 1
Before inserting a SIP, make sure that the chassis is grounded.
Step 2
To insert the SIP, carefully align the edges of the SIP between the upper and lower edges of the router slot.
Step 3
Carefully slide the SIP into the router slot until the SIP makes contact with the backplane.
Step 4
Tighten the locking thumbscrews on both sides of the SIP.
Step 5
Connect all cables to each SPA.
Removing a Shared Port Adapter from a SIP
To remove a shared port adapter (SPA), follow these steps.
SUMMARY STEPS
1. Attach an ESD wrist strap between you and an unpainted chassis surface.
2. Shut down the interface so that there is no traffic running through the shared port adapter when it is
removed.
3. Disconnect all cables from the shared port adapter.
4. Unscrew the captive installation screws on either side of the SPA.
5. Grasp the handles and pull the SPA from the SIP.
DETAILED STEPS
Step 1
Attach an ESD wrist strap between you and an unpainted chassis surface.
Step 2
Shut down the interface so that there is no traffic running through the shared port adapter when it is removed.
Removing a shared port adapter while traffic is flowing through the ports can cause system disruption.
Caution
Refer to the following example to shut down the interface FastEthernet0/1/0 on the 8-Port Fast Ethernet Shared Port
Adapter (SPA-8X1FE-TX-V2).
a) At the router# prompt, type:configure terminal and press Enter. The global configuration mode prompt Router
(config)# appears.
b) At the router (config)# prompt, type:interface FastEthernet0/1/0 and press Enter. The interface configuration mode
prompt Router(config-if)# appears.
c) At the router (config-if)# prompt, type:shutdown and press Enter. This disables the interface FastEthernet0/1/0.
d) At the router(config-if)# prompt, type:end and press Enter. The privileged EXEC mode prompt Router# appears.
Step 3
Disconnect all cables from the shared port adapter.
Step 4
Unscrew the captive installation screws on either side of the SPA.
Step 5
Grasp the handles and pull the SPA from the SIP.
Removing a Shared Port Adapter from a SIP
Cisco ASR 1000 Series Router Hardware Installation Guide
537
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
