Cisco ASR 1013 Hardware Installation Manual page 645

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Repeat Step 6 through Step 8 for the remaining two DC input power source wires, the positive lead wire and the negative

lead wire (see the following figure).

Figure 310: Inserting the DC Power Supply Terminal Block Plug in the Block Header

Secure the wires coming in from the terminal block plug so that they cannot be disturbed by casual contact.

Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block plug by casual

contact. Make sure the tie wrap allows for some slack in the ground wire as shown in the following figure.

Figure 311: Complete DC Terminal Block Plug Insertion and Secure Tie Wrap

DC power supply negative

(-) lead wire

DC power supply positive

(+) lead wire

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing DC Input Power from the Cisco ASR 1001 Router

DC power supply ground

Show Quick Links

Table of Contents

Troubleshooting