Cisco Catalyst 2360 Getting Started Manual page 4
Hide thumbs
Also See for Catalyst 2360:
- Hardware installation manual (74 pages) ,
- Software configuration manual (554 pages)
Table of Contents
Advertisement
Running Express Setup
Step 3
Power the switch by connecting the AC power
cord to the switch power supply and to a grounded
AC outlet.
Approximately 30 seconds after the switch powers
on, it begins the power-on self-test (POST), which
can take several minutes to complete.
While the software image decompresses, the
SYSTEM LED blinks green.
During POST, all LEDs are off.
When POST is complete, the SYSTEM LED turns
green, and the other LEDs reflect the status of the
corresponding module.
Before going to the next step, wait until POST is
complete. This might take up to 5 minutes.
Troubleshooting:
If the SYSTEM LED blinks green, does not turn
solid green, or turns amber, contact your Cisco
representative or reseller. The switch failed the
power-on self-test (POST).
Step 4
Press and hold the Mode button until all of the
LEDs above the Mode button turn solid green. You
might need to hold the button for 3 or more
seconds.
Release the Mode button after all LEDs above the
Mode button turn green.
The switch is now in Express Setup mode.
Before going to the next step, make sure that all
LEDs above the Mode button are solid green.
Troubleshooting:
If the LEDs above the Mode button blink after you
press the button, release it. Blinking LEDs mean
that the switch is already configured and cannot go
into Express Setup mode. For more information,
see the
Catalyst 2360 Switch Getting Started Guide
4
"Resetting the Switch" section on page
SY ST
1X
PS 1
SYST
1X
PS1
PS2
PS 2
1X
FAN
STAT
DPLX
11X 13X
FA N
SPED
11X
11X
13X
STA T
22X 25X
2X
DP LX
23X
25X
SP ED
35X 37X
12X
14X
36X
24X
26X
37X
18.
38X
Cata lyst
Cata lyst
2960 -S
2360
47X
Series
Series
PoE + 10G
47X
39X
48X
1
2
OL-22149-02
Advertisement
Table of Contents
