Server Specifications; Rack Requirements; Equipment Requirements; Slide Rail Adjustment Range - Cisco SNS 3515 Manual

Installation of ise software

Hide thumbs Also See for SNS 3515:

Hardware installation manual (41 pages)

Troubleshooting manual (8 pages)

Table Of Contents

Table of Contents

Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances

Statement 1074

Caution

Avoid UPS types that use ferroresonant technology. These UPS types can become unstable with systems

such as the Cisco UCS, which can have substantial current draw fluctuations from fluctuating data traffic

patterns.

When you are installing a server, use the following guidelines

• Plan your site configuration and prepare the site before installing the server. See the

• Ensure that there is adequate space around the server to allow for servicing the server and for adequate

• Ensure that the air-conditioning meets the thermal requirements listed in the

• Ensure that the cabinet or rack meets the requirements listed in the

• Ensure that the site power meets the power requirements listed in the

Rack Requirements

This section provides the requirements for the standard open racks.

The rack must be of the following type:

• A standard 19-in. (48.3-cm) wide, four-post EIA rack, with mounting posts that conform to English

• The rack post holes can be square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), #12-24 UNC, or

• The minimum vertical rack space per server must be one RU, equal to 1.75 in. (44.45 mm).

Equipment Requirements

The slide rails supplied by Cisco Systems for this server do not require tools for installation. The inner rails

(mounting brackets) are pre-attached to the sides of the server.

Slide Rail Adjustment Range

The slide rails for this server have an adjustment range of 24 to 36 inches (610 to 914 mm).