Table of Contents
Advertisement
11. Turn the leveling foot of the plate assembly down until it contacts the bushing, and level the rack by
tightening the lock nuts on the four leveling feet.
12. Lock the leveling feet by tightening the lock nut.
13. Insert the threaded rod into the inner hole of the leveler and the rubber bushing.
14. Thread down the threaded rod until the tip of the rod is approximately 1 inch inside the turnbuckle.
15. Insert the nuts and hand-tighten the nuts.
16. Repeat the previous three steps so that all assemblies are completely installed, as shown in the
previous illustration.
17. Tighten all the nuts to 40 ft-pounds.
The frame is now secured.
120
Eserver pSeries 670 Installation Guide
Advertisement
Table of Contents
