Multiple Hsrp - Cisco Catalyst 3750-E Software Configuration Manual

Hide thumbs Also See for Catalyst 3750-E:

Table of Contents

Understanding HSRP

Multiple HSRP

The switch supports Multiple HSRP (MHSRP), an extension of HSRP that allows load sharing between

two or more HSRP groups. You can configure MHSRP to achieve load-balancing and to use two or more

standby groups (and paths) from a host network to a server network.

B. Together, the configuration for Routers A and B establishes two HSRP groups. For group 1, Router

A is the default active router because it has the assigned highest priority, and Router B is the standby

router. For group 2, Router B is the default active router because it has the assigned highest priority, and

Router A is the standby router. During normal operation, the two routers share the IP traffic load. When

either router becomes unavailable, the other router becomes active and assumes the packet-transfer

functions of the router that is unavailable.

For MHSRP, you need to enter the standby preempt interface configuration command on the HSRP

interfaces so that if a router fails and then comes back up, preemption restores load sharing.

Active router for group 1

Standby router for group 2

Catalyst 3750-E and 3560-E Switch Software Configuration Guide

HSRPv2 has a different packet format than HSRPv1. A HSRPv2 packet uses the

type-length-value (TLV) format and has a 6-byte identifier field with the MAC address of the

physical router that sent the packet.

If an interface running HSRPv1 gets an HSRPv2 packet, the type field is ignored.

42-2, half the clients are configured for Router A, and half the clients are configured for Router

"Configuring MHSRP" section on page 42-10

MHSRP Load Sharing

for the example configuration steps.

Active router for group 2

Standby router for group 1

Configuring HSRP

Show Quick Links

Table of Contents

Catalyst3560-e