Configuring Etherchannels - Cisco Catalyst 3550 series Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for Catalyst 3550 series:
- Reference manual (58 pages) ,
- Datasheet (21 pages) ,
- Manual (19 pages)
Table of Contents
Advertisement
Chapter 30
Configuring EtherChannels
Figure 30-3 Load Distribution and Forwarding Methods
Configuring EtherChannels
These sections describe how to configure EtherChannel on Layer 2 and Layer 3 interfaces:
•
•
•
•
•
•
Note
Make sure that the interfaces are correctly configured (see the
section on page
Note
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical interfaces assigned to the port-channel interface, and configuration changes applied
to the physical interface affect only the interface where you apply the configuration.
78-11194-09
Catalyst 2950, 2955, or 3550
switch with source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 30-8
EtherChannel Configuration Guidelines, page 30-8
Configuring Layer 2 EtherChannels, page 30-9
Configuring Layer 3 EtherChannels, page 30-11
Configuring EtherChannel Load Balancing, page 30-14
Configuring the PAgP Learn Method and Priority, page 30-15
30-8).
"EtherChannel Configuration Guidelines"
Catalyst 3550 Multilayer Switch Software Configuration Guide
Configuring EtherChannels
30-7
Advertisement
Table of Contents
Troubleshooting
