Snmp Support; Configuring Snmp And Alarm Server Parameters - Cisco ASR 5500 System Administration Manual
Hide thumbs
Also See for ASR 5500:
- Administration manual (410 pages) ,
- Installation manual (192 pages) ,
- Installation procedure overview (6 pages)
Table of Contents
Advertisement
SNMP Support
SNMP Support
The system uses the SNMP to send traps or events to the EMS server or an alarm server on the network. You
must configure SNMP settings to communicate with those devices.
Important
The SNMP MIB Reference describes the MIBs and SNMP traps supported by the StarOS.
To configure the system to communicate with the EMS server or an alarm server:
Step 1
Set SNMP parameters such as UDP port, and alarm server target by applying the example configuration in
SNMP and Alarm Server Parameters, on page 62
Step 2
To view your new SNMP configuration, follow the steps in
Step 3
Save the configuration as described in Verifying and Saving Your Configuration.
Configuring SNMP and Alarm Server Parameters
Use the following example to set SNMP and alarm server parameters:
configure
system contact contact_name
system location location_name
snmp authentication-failure-trap
snmp community community_string
snmp server port port_number
snmp target name ip_address
snmp engine-id local id_string
snmp notif-threshold value low low_value period time_period
snmp user user_name
snmp mib mib_name
snmp runtime-debug [ debug-tokens token_id token_id token_id
end
Notes:
• The system contact is the name of the person to contact when traps are generated that indicate an error
• An snmp community string is a password that allows access to system management information bases
ASR 5500 System Administration Guide, StarOS Release 21.5
62
Commands used in the configuration samples in this section provide base functionality. The most common
commands and keyword options are presented. In many cases, other optional commands and keyword
options are available. Refer to the Command Line Interface Reference for complete information.
condition.
(MIBs).
Verifying SNMP Parameters, on page 63
token_id
...
Management Settings
Configuring
Advertisement
Table of Contents
Troubleshooting
