Table of Contents
Advertisement
10.8
JP/GP.SEND (Sending Data to the Programmable
Controller on Another Station)
This instruction sends data to the programmable controller on another station.
JP.SEND
GP.SEND
Setting
Internal device
1
(System, user)
data*
Bit
Word
(S1)
(S2)
(D1)
*1
Local devices and file registers set for each program cannot be used.
(1) Setting data
Setting data
Jn
Un
(S1)
(S2)
(D1)
Start contact
Start contact
Link direct device
File
J\
register
R, ZR
Bit
Word
Description
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station Access
Start I/O number of the master/local module of the own station
(00 to FE
: Upper two digits of the I/O number expressed in three
H
digits)
Start device of the own station where control data is stored
Start device of the own station where send data is stored
The device of the own station that turns on for one scan upon
completion of the instruction.
If the instruction fails, (D1)+1 also turns on.
CHAPTER 10 DEDICATED INSTRUCTIONS
JP.SEND
Jn
GP.SEND
Un
Available device
Intelligent function
Index register
module device
U\G
(S1)
(S2)
(D1)
(S1)
(S2)
(D1)
Constant
Others
Zn
K, H
$
Set by
Data type
16-bit binary
User
Device name
System
Bit
283
10
Advertisement
Table of Contents
Troubleshooting
