Configuring Cep - Cisco ASR 900 Series Configuration Manual
Interface module configuration
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (152 pages)
Table of Contents
Advertisement
Configuring CEM
Configuring CEP
To configure CEP, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
sts-1 1
mode unframed
cem-group 100 cep
end
Configuring VT-15 CEP
To configure VT-15 CEP, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
rate oc12
sts-1 1
mode vt-15
vtg 1 vt 1 cem-group 100 cep
end
Configuring DS3 SAToP
To configure DS3 SAToP, the STS-1 needs to be configured in mode T3. Use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
rate oc12
sts-1 1
mode t3
cem-group 100 unframed
interface cem 0/5/0
cem 100
xconnect 2.2.2.2 10 encapsulation mpls
end
Configuring CEM APS
To configure CEM APS, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
controller sonet-acr acr_no
sts-1 1
vtg 1 t1 1 cem-group 100 unframed
end
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuring CEP
ASR 900 Series)
5
Advertisement
Table of Contents
