Cisco Nexus 3000 Series Configuration Manual page 201
Nx-os unicast routing configuration guide,
nx-os release 5.0(3)u1(1)
Hide thumbs
Also See for Nexus 3000 Series:
- Command reference manual (356 pages) ,
- Configuration manual (182 pages) ,
- Installation manual (112 pages)
Table of Contents
Advertisement
Chapter 7
Configuring RIP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
Table 7-1
Parameters
Maximum paths for load balancing
RIP feature
Split horizon
Configuring RIP
This section includes the following topics:
•
•
•
•
•
•
•
•
•
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.
Enabling the RIP Feature
You must enable the RIP feature before you can configure RIP.
SUMMARY STEPS
1.
2.
3.
4.
Default RIP Parameters
Enabling the RIP Feature, page 7-5
Creating a RIP Instance, page 7-6
Configuring RIP on an Interface, page 7-8
Configuring a Passive Interface, page 7-11
Configuring Route Summarization, page 7-11
Configuring Route Summarization, page 7-11
Configuring Route Redistribution, page 7-12
Configuring Virtualization, page 7-13
Tuning RIP, page 7-16
configure terminal
feature rip
(Optional) show feature
(Optional) copy running-config startup-config
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Default
16
Disabled
Enabled
Configuring RIP
7-5
Hide quick links:
Advertisement
Table of Contents
