Enabling Ancp On An Atm Interface - Cisco 10000 Series Configuration Manual
Router access network control protocol
Hide thumbs
Also See for 10000 Series:
- Configuration manual (854 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter 1
Access-Network Control Protocol
Command or Action
Step 6
encapsulation dot1q [vlanid] [second-dot1q
second-vlanid]
Example:
Router(config-subif)# encapsulation dot1q 100
second-dot1q 200
Step 7
ancp enable
Example:
Router(config-subif)# ancp enable
Step 8
ancp adjacency timer interval
Example:
Router(config-subif)# ancp adjacency timer 100
Enabling ANCP on an ATM Interface
The ancp enable command should be configured only for the control VCs on which the ancp message
is sent from the DSLAM. Use the following procedure to enable ANCP on ATM interfaces.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
OL-14660-03
enable
configure terminal
ancp adjacency timer interval
interface atm slot/subslot/port.subinterface
ip address ip-address mask
pvc [vpi] [vci]
ancp enable
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Configuring Access-Network Control Protocol
Purpose
Enables dot1q VLAN encapsulation on the subinterface for
a single-queue 802.1Q VLAN or for Q-in-Q hierarchical
VLANs.
Enables ANCP on the interface where IP is configured.
Sets the ANCP adjacency timer interval, which specifies the
amount of time to wait before sending an ANCP hello
packet to the DSLAM. Valid values are defined in units of
100 milliseconds (ms). Default: 100 (10 seconds)
Purpose
Enables privileged EXEC mode. If prompted, enter your
password.
Enters global configuration mode.
1-7
Advertisement
Table of Contents
