Installing A Replacement Chassis In The Equipment Rack - Cisco 12010 series Maintenance Manual
Hide thumbs
Also See for 12010 series:
- Unpacking instructions manual (15 pages) ,
- Datasheet (9 pages) ,
- Installation and configuration manual (378 pages)
Table of Contents
Advertisement
Chapter 7
Maintaining the Router
Step 14
Warning
Warning
Installing a Replacement Chassis in the Equipment Rack
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
OL-11496-01
Remove the chassis from the rack.
An empty chassis weighs approximately 125 pounds (56.7 kg). You need two
people to remove the chassis from the equipment rack safely.
Using the side handles to support the weight of the chassis, remove the screws
a.
that attach the chassis rack mount flanges to the rack posts.
There is nothing to support the chassis in the rack when you remove the screws
if the optional rack-mount support brackets are not installed.
Carefully lift the chassis out of the rack and set it aside.
b.
Use the following procedure to install the replacement chassis and components in
the equipment rack.
Install the new chassis in the rack (see
page
3-17).
Install the power supplies (see
or
Removing and Replacing a DC PEM, page
Install the blower module (see
page
7-23).
Install cards in the line card and RP card cage (see
from the Line Card and RP Card Cage, page
Install cards in the switch fabric and alarm card cage (see
Replacing Cards from the Switch Fabric and Alarm Card Cage, page
Install the chassis air filter (see
page
7-16).
Connect all line card and interface cables (see
Interface Cables, page
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
Rack-Mounting the Router Chassis,
Removing and Replacing an AC PEM, page
Removing and Replacing the Blower Module,
Cleaning or Replacing the Chassis Air Filter,
3-36).
Removing and Installing a Chassis
7-41).
Removing and Replacing Cards
7-63).
Removing and
Connecting Line Card Network
7-32,
7-65).
7-71
Advertisement
Table of Contents
Troubleshooting
