Cisco Nexus 9348GC-FXP NX-OS Hardware Installation Manual page 33

Hide thumbs Also See for Nexus 9348GC-FXP NX-OS:

Table of Contents

Installing the Switch Chassis

Slider rail with screw holes aligned to screw holes in

rack

c) Repeat Step 3 to attach the other slider rail to the other side of the rack.

To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count

the screw holes in the vertical mounting rails.

Step 5

Insert the switch into the rack and attach it as follows:

a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or

cabinet posts that do not have slider rails attached to them (see the following figure).

Align the two rear rack-mount bracket guides with

the slider rails installed in the rack.

Slide the rack-mount guides onto the slider rails until

the front rack-mount brackets come in contact with

the front rack-mount rails.

b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the

rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front

rack-mount brackets come in contact with two rack or cabinet posts.

Two customer-supplied 12-24 or 10-32 screws used

to attach each slider rail to the rack

Front-mount brackets.

Mounting rails on rack or cabinet posts.

Cisco Nexus 9348GC-FXP NX-OS Mode Hardware Installation Guide

Installing the Switch

Table of Contents

Show Quick Links

Table of Contents