Programming Settings - Siemens SIPROTEC 7SJ62 Instruction Manual
Multi-functional protective relay with bay controller
Hide thumbs
Also See for SIPROTEC 7SJ62:
- Manual (704 pages) ,
- Technical data manual (58 pages) ,
- Manual (72 pages)
Table of Contents
Advertisement
Functions
6.4.2
Programming Settings
General
Time Delays
6-64
F# 1730
> BLOCK CLP
& Ã8PG9GP69ÃQD8FVQ
PI
PAA
"1"
52a Configured
or
52b Configured
F# 4601
>52-a
or
F# 4602
>52-b
&!ÃT‡h…‡Ã8‚qv‡v‚
7…rhxr…Ã8‚‡hp‡
I‚Ã8ˆ……r‡
"1"
! !Ã7x…8y‚†rqÃDÃHDI
Ι<
Max. of
I
, I
, I
a
b
c
Dynamic Pickup
Exceeding one of the dynamic cold pick-up thresholds of
the directional or non-directional overcurrent elements
(Address blocks 18 to 21)
Exceeding one of the „normal" pick-up thresholds of the di-
rectional or non-directional overcurrent elements
Normal Pickup
F# 1731
>BLK CLP stpTim
Figure 6-30
Logic Diagram for Dynamic Cold Load Pickup Feature
Dynamic cold load Pickup feature can only be enabled if address &ROGORDG
3LFNXS was set to (QDEOHG during configuration of protective functions. If the func-
tion is not required, address should be set to 'LVDEOHG.
There are no specific procedures on how to set the time delays at addresses &%
2SHQ 7LPH, $FWLYH 7LPH and 6WRS 7LPH. These time delays must be
based on the specific loading characteristics of the equipment being protected, and
should be selected to allow the brief overloads associated with dynamic cold load con-
ditions.
or
&
Measurement/Logic
&"Ã87ÃPƒrÃUv€r
Circuit-
Breaker
&
Closed
0
or
&
&
&#Ã6p‡v‰rÃUv€r
0
&$ÃT‡‚ƒÃUv€r
0
&
F# 1995
CLP BLOCKED
F# 1996
or
CLP running
F# 1994
CLP OFF
T
Dyn Set. Activated
S Q
Processing of the
cold load pick-up
R
settings in the overcurrent
elements
T
or
T
7SJ62 Manual
C53000-G1140-C121-1
Advertisement
Table of Contents
