hit counter script
Honeywell HE225 Installation Instructions And Owner's Manual
Honeywell HE225 Installation Instructions And Owner's Manual

Honeywell HE225 Installation Instructions And Owner's Manual

Bypass flow-through humidifier
Hide thumbs Also See for HE225:

Advertisement

Available languages

Available languages

HE225
Bypass Flow-Through Humidifier
APPLICATION
The HE225 Bypass Flow-Through Humidifier uses the warm air
furnace blower to provide humidification for the whole house.
INSTALLATION
WARNING
Hazardous Voltage.
Can cause personal injury or equipment damage.
Do not cut or drill into any air conditioning or electrical
accessory.
CAUTION
Freezing Water and High Water or Static Pressure Hazard.
Can cause water damage or permanent equipment
damage.
• The humidifier must be located where the ambient
temperature is above 32°F (0°C) and below 160°F (71°C).
• Be sure supply plenum static pressure is no greater than
0.3 in. w and water pressure is no greater than 125 psi.
IMPORTANT
To assure optimal product performance, be sure the template
is level before marking.
1. Determine the best location for the humidifier and draw a level
line on the plenum. See Fig. 1.
Template (entire sheet) Top of Humidifier
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT
2. Tape this piece of paper in position as your template and trace
3. Remove the template and carefully cut the rectangular opening.
4. Disassemble the humidifier. Remove the cover and take out the
Template (entire sheet)

INSTALLATION INSTRUCTIONS

HUMIDIFIER
T A
BYPASS
O N
R I Z
COLLAR
H O
O Y
W B
L O
Fig. 1. Typical humidifier installation locations.
Mount the humidifier at least 3 in. (76 mm) above the furnace
jacket to allow adequate space for the solenoid valve and
drain line. Check that there is adequate space above the
humidifier to remove and install the humidifier cover. Do not
install on a furnace jacket.
around the template.
humidifier pad assembly. See Fig. 2.
L
O Y
H B
H I G
W N
D O
O
F L
M12248D
69-1425EF-03

Advertisement

Table of Contents
loading

Summary of Contents for Honeywell HE225

  • Page 1: Installation Instructions

    Template (entire sheet) Top of Humidifier HE225 Bypass Flow-Through Humidifier INSTALLATION INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS APPLICATION HUMIDIFIER The HE225 Bypass Flow-Through Humidifier uses the warm air furnace blower to provide humidification for the whole house. BYPASS R I Z COLLAR INSTALLATION WARNING H I G Hazardous Voltage.
  • Page 2 The damper is specifically designed with snap features for use spe- mounting tabs into the knockout hole and firmly tighten the cifically with Honeywell humidifiers. It is not intended for use in locking screw. Field wiring connections and grounding means any other application.
  • Page 3: Plumbing Saddle Valve

    Template (entire sheet) Top of Humidifier HE225 BYPASS FLOW-THROUGH HUMIDIFIER For humidity control wiring connections: NOTE: Lightly clean the copper tubing ends with fine sand- 1. Wire the humidifier solenoid valve, current sensing relay or sail paper before making any connections.
  • Page 4 Template (entire sheet) Top of Humidifier HE225 BYPASS FLOW-THROUGH HUMIDIFIER Automation and Control Solutions Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 Honeywell Limited-Honeywell Limitée ® U.S. Registered Trademark © 2010 Honeywell International Inc. 35 Dynamic Drive 69-1425EF—03...
  • Page 5: Installation

    INSTRUCTIONS D'INSTALLATION VEUILLEZ LIRE CES INSTRUCTIONS ET LES CONSERVER APPLICATION HUMIDIFICATEUR L' humidificateur à dérivation et à passage direct HE225 utilise le ventilateur de l’appareil de chauffage à air chaud pour humidifier toute la maison. T A L COLLIER DE R I Z DÉRIVATION...
  • Page 6 Gabarit (feuille entière). Partie supérieure de l’humidificateur HUMIDIFICATEURS À CIRCULATION DIRECTE ET À DÉRIVATION HE225 REMARQUE : S'assurer d'installer un registre dans la gaine pour la mise hors service en été, s'il y a un système de GICLEUR D’ARRIVÉE D’EAU climatisation.
  • Page 7: Tuyauterie Du Robinet-Vanneà Étrier

    Gabarit (feuille entière). Partie supérieure de l’humidificateur HUMIDIFICATEURS À CIRCULATION DIRECTE ET À DÉRIVATION HE225 RACCORDEMENT DE L'HYGROSTAT : REMARQUE : Avant d'effectuer les raccords, nettoyer légèrement l'extrémité des tuyaux avec un papier de verre fin. 1. Câbler l'électrovanne de l'humidificateur, le relais de détection de courant ou l'interrupteur à...
  • Page 8 Gabarit (feuille entière). Partie supérieure de l’humidificateur HUMIDIFICATEURS À CIRCULATION DIRECTE ET À DÉRIVATION HE225 Solutions de régulation et d’automatisation Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 Honeywell Limited-Honeywell Limitée ® Marque de commerce déposée aux É.-U.

Table of Contents