Removing And Installing The Sas/Sata Backplane Board - Acer Altos R720 Series User Manual
2u rack optimized server
Hide thumbs
Also See for Altos R720 Series:
- Installation & configuration manual (104 pages) ,
- Installation & configuration manual (42 pages)
Table of Contents
Advertisement
Removing and installing the SAS/SATA
backplane board
To remove the SAS/SATA backplane board:
1
Observe the ESD precautions and pre-installation instructions
described on page 35.
2
Remove the air baffles. See "To remove the small air baffle"
section on page 45.
3
Make sure all hot-plug HDD carriers are removed from the drive
bay. For instructions, see "To remove a HDD" section on page 48.
4
Disconnect all cables attached to the backplane board.
5
Remove the SAS mid-plane board. See previous section.
Note: To prevent damage to your system, make sure to remove
the mid-plane board first before attempting to remove the
backplane board.
6
Hold the backplane board by its edges, then lift it from the chassis.
7
Store the backplane board in an antistatic protective wrapper.
8
Observe the post-installation instructions described on page 36.
89
Advertisement
Table of Contents
Troubleshooting
