Mpls L3Vpn Overview - Cisco NCS 540 Series Configuration Manual

L3vpn; for ios xr release 6.3.x

Hide thumbs Also See for NCS 540 Series:

Table of Contents

MPLS L3VPN Overview

Before defining an MPLS VPN, VPN in general must be defined. A VPN is:

• An IP-based network delivering private network services over a public infrastructure

• A set of sites that are allowed to communicate with each other privately over the Internet or other public

or private networks

Conventional VPNs are created by configuring a full mesh of tunnels or permanent virtual circuits (PVCs) to

all sites in a VPN. This type of VPN is not easy to maintain or expand, as adding a new site requires changing

each edge device in the VPN.

MPLS-based VPNs are created in Layer 3 and are based on the peer model. The peer model enables the service

provider and the customer to exchange Layer 3 routing information. The service provider relays the data

between the customer sites without customer involvement.

MPLS VPNs are easier to manage and expand than conventional VPNs. When a new site is added to an MPLS

VPN, only the edge router of the service provider that provides services to the customer site needs to be

updated.

The following figure depicts a basic MPLS VPN topology.

Figure 1: Basic MPLS VPN Topology

These are the basic components of MPLS VPN:

L3VPN Configuration Guide for Cisco NCS 540 Series Routers, IOS XR Release 6.3.x

C H A P T E R

Table of Contents

Show Quick Links

Table of Contents