hit counter script

Configuring The Pos Spas - Cisco ASR 1000 Series Software Configuration Manual

Aggregation services routers sip and spa, cisco ios xe everest 16.5
Table of Contents

Advertisement

Configuring the POS SPAs

This chapter provides information about configuring the Packet over SONET (POS) shared port adapters
(SPAs) on the Cisco ASR 1000 Series Aggregation Services Routers. This chapter includes the following
sections:
For information about managing your system images and configuration files, refer to the
Configuration Fundamentals Configuration Guide, Release 2
Command Reference
Configuration Tasks
This section describes how to configure POS SPAs and includes information about verifying the configuration.
It includes the following topics:
Specifying the Interface Address on a SPA
SPA interface ports begin numbering with "0" from left to right. Single-port SPAs use only the port number
0. To configure or monitor SPA interfaces, you need to specify the physical location of the SIP, SPA, and
interface in the CLI. The interface address format is slot/subslot/port, where:
• slot—Specifies the chassis slot number in the Cisco ASR 1000 Series Router where the SIP is installed.
• subslot—Specifies the secondary slot of the SIP where the SPA is installed.
• port—Specifies the number of the individual interface port on a SPA.
The following example shows how to specify the first interface (0) on a SPA installed in the first subslot of
a SIP (0) installed in chassis slot 2:
Router(config)# interface serial 2/0/0
OL-14127-17
publications that correspond to your Cisco IOS XE software release.
Configuration Tasks, page 195
Verifying the Interface Configuration, page 204
Configuration Examples, page 205
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
13
C H A P T E R
and
Cisco IOS Configuration Fundamentals
Cisco IOS XE
Everest 16.5
195

Advertisement

Table of Contents
loading

Table of Contents