Configuring The Rtcp On The Spa-Dsp - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Configuring the Cisco DSP SPA for the ASR 1000 Series Aggregation Services Routers
HA State : DSP_HA_STATE_PENDING1
Max signal/voice channel: 43/43
Max credits: 645
num_of_sig_chnls_allocated: 43
Transcoding channels allocated: 43
Group: FLEX_GROUP_XCODE, complexity: LOW
Configuring the RTCP on the SPA-DSP
This section provides details of the procedure to enable the generation and termination of the RTCP on the
SPA-DSP. From the Cisco IOS XE Release 3.4.0S onwards, the SPA-DSP can terminate and generate the
RTCP data.
Configuring the RTCP on the SPA-DSP on the Cisco Unified Border Element
for the Unified Model
To configure the RTCP on the SPA-DSP on the Cisco Unified Border Element: Unified Model, perform the
following steps:
SUMMARY STEPS
1. enable
2. configure terminal
3. sbc sbc-name
4. rtcp-regenerate
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
sbc sbc-name
Example:
Router(config)# sbc mySBC
OL-14127-17
Shared credits: 0, reserved credits: 645
Transcoding channels allocated: 24
Credits used (rounded-up): 360
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring the RTCP on the SPA-DSP
Purpose
Enables the privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration (config) mode.
Creates an SBC service on the Cisco Unified Border Element
and enters into the SBC configuration mode.
Everest 16.5
413
Advertisement
Chapters
Table of Contents
Troubleshooting
