Configuring The Mac Address Limit - Cisco CRS Configuration Manual
Ios xr virtual private network
Hide thumbs
Also See for CRS:
- Configuration manual (430 pages) ,
- User manual (304 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Configuring the MAC Address-related Parameters
PW: neighbor 1.1.1.1, PW ID 1, state is down ( local ready )
PW class not set, XC ID 0xff000001
Encapsulation MPLS, protocol LDP
PW type Ethernet, control word enabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
------------ ------------------------------ -------------------------
------------ ------------------------------ -------------------------
Create time: 19/11/2007 15:20:14 (00:25:25 ago)
Last time status changed: 19/11/2007 15:44:00 (00:01:39 ago)
MAC withdraw message: send 0 receive 0
Configuring the MAC Address Limit
Perform this task to configure the parameters for the MAC address limit.
Note
MAC Address Limit action is supported only on the ACs and not on the core pseudowires.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge group name
4. bridge-domain bridge-domain name
5. (Optional) interface type interface_id
6. mac
7. limit
8. maximum { value }
9. action { flood | no-flood | shutdown }
10. notification { both | none | trap }
11. Use the commit or end command.
12. show l2vpn bridge-domain [ detail ]
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
98
MPLS
Local
Label
30005
Group ID
0x0
Interface
siva/vfi
MTU
1500
Control word enabled
PW type
Ethernet
Implementing Multipoint Layer 2 Services
Remote
unknown
0x0
unknown
unknown
unknown
unknown
Advertisement
Table of Contents
