Chapter6 Parameter Setting; Parameter Setting Procedure - Mitsubishi Electric Melsec Q Series User Manual
Profibus-dp master module
Hide thumbs
Also See for Melsec Q Series:
- User manual (834 pages) ,
- Reference manual (674 pages) ,
- Programming manual (624 pages)
Table of Contents
Advertisement
6
PARAMETER SETTING
CHAPTER6 PARAMETER SETTING
This chapter describes the procedure for setting QJ71PB92V parameters and details of
the parameters.
In this chapter, parameter settings when programs are created using GX Works2 are
described.
6.1 Parameter Setting Procedure
The following describes the QJ71PB92V parameter setting procedure.
(1) Setting procedure
Install GX Configurator-DP on the personal computer.
Start GX Configurator-DP, and register GSD (DDB) files of
DP-Slaves.
Create new parameters. (Select the module model.)
Set Master Parameters.
Set Bus Parameters.
Set Slave Parameters.
Set the automatic refresh parameter.
Write the parameters set on GX Configurator-DP to
QJ71PB92V.
6
- 1
6.1 Parameter Setting Procedure
Start
Use the automatic
refresh function?
Yes
1)
(To the next page)
Figure 6.1 Parameter Setting Procedure
GX Configurator-DP Version7
Operating Manual
Section 6.3
Section 6.4
Section 6.5
No
Section 6.6
• GX Configurator-DP Version7
Operating Manual
• (2) in this section
Advertisement
Table of Contents
Troubleshooting
