Emergency Number (Sos); Charge Battery - Siemens SX1 User Manual
Siemens cell phone user guide
Hide thumbs
Also See for SX1:
- User manual (119 pages) ,
- Repair documentation (40 pages) ,
- Manual (103 pages)
Table of Contents
Advertisement
Emergency number
(SOS)
Must only be used in real emergen-
cies!
Switch the phone on and check for
adequate signal strength.
E
Press to go to standby if in
a menu or application.
M
Key in the emergency
number (e.g. 112 or
other official emergency
numbers).
D
Press to call the number.
You can make an emergency call on
any network without a SIM card and
without entering a PIN (not available
in all countries).
Charge battery
The battery is not fully charged
when delivered. Plug in the charger
cable at the bottom of the phone,
plug in the power supply unit to the
mains power socket and charge for
at least two hours.
Display when charging is in
progress
h
During charging.
Getting Started
Charging time
An empty battery is fully charged
after about 1 - 1.5 hours. Charging is
only possible in an ambient tempera-
ture of 5 °C to 40 °C (the charge icon
flashes as a warning when the tem-
perature is 5 °C above/below this
range). The mains voltage specified
on the power supply unit must not
be exceeded.
Charge icon not visible
If the battery is totally discharged
no charge icon is displayed when
the charger is plugged in. It will ap-
pear after two hours at most. In this
case the battery is fully charged after
1.5 - 2 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
a d g
A beep sounds when the battery is
nearly empty.
Note
The charger heats up when used for long
periods. This is normal and not dangerous.
Operating times
Standby time up to 200 hours, and up to
240 minutes talk time, depended on the
operating conditions.
7
Advertisement
Table of Contents
