Connecting The Fm And Am(Mw/Lw) Antennas; Connecting The Video To Tv - Samsung HT-DB390 Instruction Manual
Hide thumbs
Also See for HT-DB390:
- Instruction manual (76 pages) ,
- Instruction manual (35 pages) ,
- Instruction manual (72 pages)
Table of Contents
Advertisement
Connecting the FM and AM
If AM reception is poor, connect an
outdoor AM antenna(not supplied).
If FM reception is poor,
connect an outdoor FM
antenna (not supplied).
FM Antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75Ω
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75Ω coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
Cooling Fan
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
•
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
15
Antennas
( MW/LW )
1
2
3
AM Loop Antenna
(supplied)
ANTENNA
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AM
antenna connection
(MW/LW)
1. Connect the AM loop antenna supplied
to the AM and
terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
Connecting the Video to TV
TV
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the system
to the VIDEO IN jack on your television.
Scart (Best Quality)
If you television is equipped with an SCART input, connect an Scart Jack (not supplied) from
the AV OUT jack on the back panel of the system to the SCART IN jack on your television.
For using the SCART cable
• If Scart is equipped for your TV, set RGB-COMPOSITE selector of
the center unit to RGB. You can get a better picture quality by
using Scart setting.
• If Scart (RGB Input) is not equipped for your TV, set RGB-
COMPOSITE selector to COMPOSITE.
•
On the rear panel SCART cable is indicated as "AV OUT."
Note
VIDEO
SCART
IN
IN
RGB
COMPOSITE
RGB
COMPOSITE
16
Advertisement
Table of Contents
