Verifying Trunking Configuration - Cisco MDS 9000 Series Configuration Manual
Interface
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Verifying Trunking Configuration
Verifying Trunking Configuration
To display trunking configuration information, perform one of the following tasks:
Command
show interface fc slot/port
show trunk protocol
show interface trunk vsan numbers
For detailed information about the fields in the output from these commands, refer to the
Command
The show interface command is invoked from the EXEC mode and displays trunking configurations for a
TE port. Without any arguments, this command displays the information for all of the configured interfaces
in the switch. See Examples
Information on Trunk Ports, on page
Displays a Trunked Fibre Channel Interface
switch# show interface fc1/13
fc1/13 is trunking
Displays the Trunking Protocol
switch# show trunk protocol
Trunk protocol is enabled
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
212
Reference.
Displays a Trunked Fibre Channel Interface, on page 212
Hardware is Fibre Channel
Port WWN is 20:0d:00:05:30:00:58:1e
Peer port WWN is 20:0d:00:05:30:00:59:1e
Admin port mode is auto, trunk mode is on
Port mode is TE
Port vsan is 1
Speed is 2 Gbps
Receive B2B Credit is 255
Beacon is turned off
Trunk vsans (admin allowed and active) (1)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
233996 frames input, 14154208 bytes, 0 discards
0 CRC, 0 unknown class
0 too long, 0 too short
236 frames output, 13818044 bytes, 0 discards
11 input OLS, 12 LRR, 10 NOS, 28 loop inits
34 output OLS, 19 LRR, 17 NOS, 12 loop inits
Purpose
Displays the interface configuration information that includes trunking,
trunk mode, allowed VSANs, and status.
Displays whether the trunk protocol is enabled.
Displays whether the interface is trunking, and the allowed VSAN list
for each trunking interface.
213.
(1)
()
()
Configuring Trunking
Cisco MDS NX-OS
to
Displays Per VSAN
- Quick Links:
- E Port
- Configuring Isl between Two Switches
Hide quick links:
Advertisement
Table of Contents
