Cisco Nexus 9348GC-FXP Hardware Installation Manual page 37

Aci mode

Hide thumbs Also See for Nexus 9348GC-FXP:

Table of Contents

Installing the Switch Chassis

• The rack must be close enough to the dedicated power source so that you can connect the switch to the

• You have the designated power cables for the power supplies that you are connecting to the dedicated

• The switch is not connected to the network (this includes any management or interface connections).

• The fan and power supply modules are fully secured in their chassis slots.

Step 1

For each AC power supply, do the following:

a) Using the recommended AC power cable for your country or region, connect one end to the AC power supply.

b) Connect the other end of the power cable to the AC power source.

Step 2

Verify that the power supply

Step 3

Listen for the fans; they should begin operating when the power supply is powered.

Step 4

After the switch boots, verify that the following LEDs are lit:

• On the fan modules, the Status (STA or STS) LED is green.

If a fan module Status LED is not green, try reinstalling the fan module.

• After initialization, the switch chassis Status (labeled as STA or STS) LED is green.

Step 5

Verify that the system software has booted and the switch has initialized without error messages.

Note

A setup utility automatically launches the first time that you access the switch and guides you through the basic

configuration. For instructions on how to configure the switch and check module connectivity, see the appropriate Cisco

Nexus configuration guide.

power source by using a designated power cables.

power sources.

Note

Depending on the outlet receptacle on your AC power distribution unit, you might

need an optional jumper power cord to connect the switch to your outlet receptacle.

All of the fan slots must be filled with fan modules and the power supply slots must be filled with the

same types of power supplies (do not mix AC and DC power supplies).

LED is on and green.

Cisco Nexus 9348GC-FXP ACI Mode Hardware Installation Guide

Starting the Switch

Table of Contents