Table of Contents
Advertisement
4-Port OC-3 STM-1/OC-12 STM-4 POS SPA LEDs
4-Port OC-3 STM-1/OC-12 STM-4 POS SPA LEDs
The 4-Port OC-3 STM-1/OC-12 STM-4 POS SPA has three LEDs: two LEDs for each port on the SPA and
one STATUS LED. The following figure shows the 4-Port OC-3 STM-1/OC-12 STM-4 POS SPA faceplate.
Figure 44: 4-Port OC-3 STM-1/OC-12 STM-4 POS SPA Faceplate
1
C/A (Carrier/Alarm) LED
2
A/L (Active Loopback) LED
The 4-Port OC-3 STM-1/OC-12 STM-4 POS SPA LEDs are described in the following table.
Table 34: 4-Port OC-3 STM-1/OC-12 STM-4 POS SPA LEDs
LED Label
C/A
A/L
STATUS
4-Port OC-3 STM-1/OC-12 STM-4 POS SPA Interface Specifications
The framer processes incoming and outgoing SONET or SDH frames. The framer operates at OC-3 line rates
(155.52 Mbps) and OC-12 line rates (622.08 Mbps). Packet data is transported with a user-configured
encapsulation (such as Point-to-Point Protocol [PPP]) and is mapped into the layer 2 frame.
The 4-Port OC-3 STM-1/OC-12 STM-4 POS SPA interface complies with the following IETF RFCs:
• RFC 1662, PPP in HDLC-like Framing
• RFC 2427, Frame Relay Encapsulation
• RFC 2615, PPP over SONET/SDH
Cisco ASR 9000 Series Aggregation Services Router SIP and SPA Hardware Installation Guide
54
3
STATUS LED
Color
State
Meaning
Off
Off
SONET controller is shut down.
Green
On
Port is enabled by software, and there is a valid SONET signal without any alarms.
Amber
On
Port is enabled by software, and there is at least one alarm.
Off
Off
Interface is shut down.
Green
On
Port is enabled by software, loopback is off.
Amber
On
Port is enabled by software, loopback is on.
SPA power is off.
Off
Off
Green
On
SPA is ready and operational.
Amber
On
SPA power is on and good; SPA is being configured.
Overview: Cisco ASR 9000 Series Router Shared Port Adapters
Advertisement
Table of Contents
