Table of Contents
Advertisement
Settings of the slave module
Write addresses to slave modules to register the RJ51AW12AL.
Address setting
Write addresses to slave modules with an address writer.
• Output ASLINKER: Address 0 (ID: 0000H)
• Input ASLINKER: Address 0 (ID: 0200H)
Automatic address detection
Keep pressing the SET switch on the RJ51AW12AL until the SET LED turns on.
When the SET LED flashes and then turns off, it indicates that the registration of IDs (addresses) has been completed.
Checking the system status
Check whether the RJ51AW12AL can communicate with the slave modules normally.
The following LED statuses indicate that the communication is established normally.
• LED of the RJ51AW12AL
LED
RUN LED
ERR LED
LINK LED
SET LED
ALM LED
• LED of the ASLINKER
LED
LINK LED
ALM LED
Status
On
Off
Flashing
Off
Off
Status
Flashing
Off
7 COMMUNICATION EXAMPLE
7.1 Communication of RJ51AW12AL with Slave Module
7
37
Advertisement
Table of Contents
