Removing The Paper Roll And Ink Ribbon - Sony SnapLab UP-CR20L Operating Instructions Manual

Digital photo printer

Hide thumbs Also See for SnapLab UP-CR20L:

Table of Contents

Enlarged version

Enter the administrator password using the numeric

keypad, and touch [OK].

(The factory default setting for the password is

"9999.")

The ribbon door unlocks, and the error message screen

returns. The key icon at the top right changes to "!,"

indicating that the door is unlocked.

Removing the Paper Roll and Ink

Ribbon

Note

The above message is set to appear before the ink

ribbon and paper roll are completely used up. Even if

there is some ink ribbon and paper remaining, be sure

to load a new ink ribbon and paper roll.

Remove the output cover and output tray.

Replacing the Paper Roll and Ink Ribbon

Remove and empty the scrap receptacle.

Note

If the scrap receptacle becomes too full, scraps that are

cut off may be unable to eject. This may result in

malfunction. Be sure to empty the scrap receptacle

each time you replace the paper roll.

Press and lower the paper door lever, hold the paper

door at the center portion, and pull the door forward

until it locks into the open position.

Table of Contents

Show Quick Links

Table of Contents