Installing The Power Cord Retainer (Optional) - Cisco Catalyst 2960-L Series Hardware Installation Manual
8-port and 16-port switch
Hide thumbs
Also See for Catalyst 2960-L Series:
- Getting started manual (20 pages) ,
- Installation manual (22 pages) ,
- Hardware installation manual (72 pages)
Table of Contents
Advertisement
Installing the Power Cord Retainer (Optional)
Step 2
Pull down on the DIN rail mount release tabs. As the clips release, lift the bottom of the switch.
Figure 26: Switch Removal
Installing the Power Cord Retainer (Optional)
Note
This section applies to switches with an AC power connector.
The power cord retainer (PWR-CLP=) is optional. You can order it when you order your switch, or you can
order it later from your Cisco representative.
Step 1
Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve can be snapped
off and used for thin cords.
Step 2
Slide the retainer around the AC power cord, and pass it around the loop on the switch.
Cisco Catalyst 2960-L Series 8-Port and 16-Port Switch Hardware Installation Guide
32
Switch Installation
Hide quick links:
Advertisement
Table of Contents
