Table of Contents
Advertisement
vEdge 2000 Router
Mount the vEdge 2000 Router on Mid-Posts
To mount a vEdge 2000 router on two mid-posts in a 19-inch rack:
1. Place the router chassis on the floor or on a sturdy table near the rack.
2. Verify the internal dimensions of the rack with a tape measure. The chassis is 440 mm wide and must fit
within the mounting posts.
3. Secure the two short mounting ears, marked Left and Right, to either side of the router chassis using the
eight screws for mounting ears (four on each side) in the packet marked B.
Figure 11: Attaching the Short Mounting Ears to the Center of the Router Chassis
1. Grasp both sides of the router, then lift and position it in the rack, making sure that the mounting ear holes
are aligned with the threaded holes in the rack rail. Align the bottom hole in both the mounting ears with
a hole in each rack rail, making sure the chassis is level.
Figure 12: Positioning the vEdge 2000 Router in the Rack
1. Have a second person attach the mounting ears to the rack, using four rack-mount screws (two on each
side) from the packet marked A. Tighten the screws.
Install the vEdge 2000 Router
Hardware Installation Guide for vEdge Routers
193
Advertisement
Table of Contents
Troubleshooting
