Siemens SINUMERIK 840D Operator's Manual page 377
Hmi advanced
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
7
03.04
Length
Date
Enabling
Access authorization
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Notice: Data may only be loaded for programs for which an enable
has been set!
File length in bytes (directory length is not displayed)
Date of creation or date of last modification to file
Enable (=selection/right to execute) activated "X" or not activated " "
When you set up a program, you may not necessarily be able to
process it immediately with an NC start (e.g. if it is not ready or
requires testing).
To indicate that a program is ready for NC Start, it is possible to
enable or disable the program.
The current state of a file is indicated by an "X" in the "Enable" column
(= enable activated).
There are also 5 access rights for each file:
· Read
· Write
· Execute
· Display
· Delete
The access right for each file is indicated in the file tree.
Not every operator should be able to edit data and programs on the
control. Access levels are therefore defined for each file. They range
from level 0 (SIEMENS password) to level 7 (keyswitch 0).
A description of how to set the access rights is given in Chapter
"Properties".
The access rights are not displayed as the numbers 1-7 in the display,
instead the display only includes objects which can be executed
depending on the rights assigned when the control was started.
"Services" Operating Area
7.5 Operation
Corresponds to level 5
Corresponds to level 3
Corresponds to level 7
Corresponds to level 2
Corresponds to level 1
7
7-377
Advertisement
Chapters
Table of Contents
