Siemens SINUMERIK 840D sl Programming Manual page 919
Nc programming
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Commissioning manual (1102 pages) ,
- Diagnostic manual (1054 pages)
Table of Contents
Advertisement
Variant 3:
The EG axis group is selectively switched-in with synchronization and the approach mode
specified with:
EGONSYNE(FA,"block change mode",SynPosFA,approach
mode[,LAi,SynPosLAi,Zi,Ni])
Meaning
Variant 1:
FA
Block change mode:
LA1, ... LA5
Z1, ... Z5
N1, ... N5
Only the leading axes previously specified with the EGDEF command may be programmed in
the activation line. At least one leading axis must be programmed.
Variant 2:
FA
Block change mode:
[,LAi,SynPosLAi,Zi,Ni]
LA1, ... LA5
SynPosLAi
Z1, ... Z5
N1, ... N5
Only leading axes previously specified with the EGDEF command may be programmed in the
activation line. Through the programmed "Synchronized positions" for the following axis
(SynPosFA) and for the leading axes (SynPosLA), positions are defined for which the axis
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Following axis
The following modes can be used:
Block change takes place immediately
"NOC"
Block change is performed in "Fine synchronism"
"FINE"
Block change is performed in "Coarse synchron‐
"COARSE"
ism"
Block change is performed for setpoint-based
"IPOSTOP"
synchronism
Leading axes
Numerator for coupling factor i
Denominator for coupling factor i
Coupling factor i = numerator i/denominator i
Following axis
The following modes can be used:
Block change takes place immediately
"NOC"
Block change is performed in "Fine synchron‐
"FINE"
ism"
Block change is performed in "Coarse synchron‐
"COARSE"
ism"
Block change is performed for setpoint-based
"IPOSTOP"
synchronism
(do not write the square brackets)
Min. 1, max. 5 sequences of:
Leading axes
Synchronized position for i-th leading axis
Numerator for coupling factor i
Denominator for coupling factor i
Coupling factor i = numerator i/denominator i
Work preparation
3.16 Axis couplings
919
- Quick Links:
- Programming Manual
Hide quick links:
Advertisement
Table of Contents
