Install Sfps; Laser Safety Guidelines - Cisco 4000 Series Hardware Installation Manual
Integrated services routers
Hide thumbs
Also See for 4000 Series:
- Upgrade manual (24 pages) ,
- Installation manual (18 pages) ,
- Manual (52 pages)
Table of Contents
Advertisement
Chapter 5
Install and Upgrade Internal Modules and FRUs
Install SFPs
Laser Safety Guidelines
Optical SFPs use a small laser to generate the fiber-optic signal. Keep the optical transmit and receive
ports covered whenever a cable is not connected to the port.
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
To install an SFP module in your router:
Read the
Step 1
replace any module.
Slide the SFP into the router connector until it locks into position (see
Step 2
If the SFP uses a bale-clasp latch (see
Tip
Figure 5-56
Do not remove the optical port plugs from the SFP until you are ready to connect cabling.
Caution
Connect the network cable to the SFP module.
Step 3
OL-32185-02
"Safety Warnings" section on page 5-2
Install an SFP Module
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
section, and disconnect the power supply before you
Figure
5-56), the handle should be on top of the SFP module.
Install and Remove SFP Modules
Figure
5-56).
5-77
Hide quick links:
Advertisement
Table of Contents
