Mitsubishi Electric Melsec Q Series Programming Manual page 340

Motion controller (sv13/sv22)

Hide thumbs Also See for Melsec Q Series:

Table of Contents

5 OPERATION CONTROL PROGRAMS

Setting data

(1) (n) words of data from the device specified with (S) are written to the address

specified with (D3) and after of the buffer memory in the intelligent function

module specified with (D2).

The intelligent function module is mounted to the target SSCNET /H head

module specified with (D1).

After writing completion of the device data, the complete bit device specified with

(D4) turns ON.

SSCNET /H head module

function module

buffer memory

(2) First I/O No. of the module mounted to the SSCNET /H head module set by

system setting is specified by (D2).

(D2) sets 05H by the system setting when a RTO instruction is executed in the

D/A conversion module (L60DA4).

(3) The word devices that may be set at (D1), (D2), (D3), (S), (n), and (D4) are shown

Word devices

Write the data

of a part for

(Note-1): The device No. cannot be specified indirectly.

(Note-2): Specify a multiple of 16 as the device number of bit data.

(Note-3): PX and PY cannot be set.

Device memory

(Note-1), (Note-2)

Show Quick Links

Table of Contents