Table of Contents
Advertisement
Activating an AC Power Supply
Activating an AC Power Supply
Perform the following procedure to activate an AC power supply:
Procedure
Step 1
Plug the power cord into the power supply.
Step 2
Connect the other end of the power cord to an AC-input power source.
Step 3
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is
green.
Step 4
If the LEDs indicate a power problem, see the Troubleshooting section for troubleshooting information.
Step 5
If you are connecting a redundant AC power supply, repeat these steps for the second power source.
Note
Connecting a Router to the Network
The sections describe how to connect a Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M
Router to the network:
Note
Connect only SELV services to all the Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M
Router ports.
Connecting Console Cables
This section describes how to connect to the Cisco ASR 920 Router using console cables:
Connecting to the USB Serial Port Using Microsoft Windows
This procedure shows how to connect to the USB serial port using Microsoft Windows.
Note
Install the USB device driver before establishing a physical connection between the router and the PC, by
plugging the USB console cable into the USB serial port. Otherwise, the connection fails. For more information,
see the Installing the Cisco USB Device Driver section.
Installing the Router
44
If you are connecting a redundant AC power supply, ensure that each power supply is connected
to a separate power source in order to prevent power loss in the event of a power failure.
Installing the Router
Advertisement
Table of Contents
