hit counter script

Power-On Sequence For Switch Data Stacks - Cisco Catalyst 3650 Series Hardware Installation Manual

Hide thumbs Also See for Catalyst 3650 Series:
Table of Contents

Advertisement

Chapter 2
Switch Installation
Figure 2-4
connections. This stack provides only half bandwidth and does not have redundant connections.
Figure 2-4
Figure 2-5
Figure
does not have redundant connections. In
two stacks, and the top and bottom switches become the active switches in the stack. If the bottom switch
is a member (not the active or standby switch), it reloads.
Figure 2-5
Figure 2-6

Power-On Sequence for Switch Data Stacks

Consider these guidelines before you power on the switches in a stack:
OL-29734-01
shows an example of a stack of Catalyst 3650 switches with incomplete StackWise cabling
Example of a Data Stack with Half Bandwidth Connections
1
2
and
Figure 2-6
show data stacks of Catalyst 3650 switches with failover conditions. In
2-5, the StackWise cable is bad in link 2. Therefore, this stack provides only half bandwidth and
Example of a Data Stack with a Failover Condition
1
3
Example of a Partitioned Data Stack with a Failover Condition
1
2
The sequence in which the switches are first powered on might affect the choice of switch that
becomes the active switch and the standby switch.
There are two ways to elect an active switch:
If you want a particular switch to become the active switch, configure it with the highest
priority. Among switches with same priority, the switch with the lowest MAC address becomes
the active switch.
PWR-C2-250WAC
PWR-C2-250WAC
PWR-C2-250WAC
Figure
2-6, link 2 is bad. Therefore, this stack partitions into
PWR-C2-250WAC
PWR-C2-250WAC
2
PWR-C2-250WAC
PWR-C2-250WAC
PWR-C2-250WAC
PWR-C2-250WAC
Catalyst 3650 Switch Hardware Installation Guide
Planning a Switch Data Stack
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
PWR-C2-640WAC
2-7

Advertisement

Table of Contents
loading

Table of Contents