Table of Contents
Advertisement
Figure 49. Installing a 1.8-inch SSD blank
a. SSD blank
b. release latch
Next steps
Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions
on page 51
Related tasks
Removing a hard drive or SSD
Shutdown procedure for servicing a hard drive
NOTE:
This section applies only to situations where the server module must be turned off to service a hard drive. In
many situations, the hard drive can be serviced while the server module is turned on.
If you need to turned off the server module to service a hard drive, wait 30 seconds after the server module power indicator turns off
before removing the hard drive. Otherwise, the hard drive may not be recognized after it is reinstalled and the server module is turned on
again.
Configuring the boot drive
The drive or device from which the system boots is determined by the boot order specified in the System Setup.
Removing a 2.5-inch hard drive or SSD from a 2.5-inch
hard drive or SSD carrier
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
on page 94
Installing and removing server module components
99
Advertisement
Table of Contents
Troubleshooting
