Table of Contents
Advertisement
Installing the Cisco NCS 560-4 Router
Figure 41: Installing the Slave Fan Tray (N560-4-FAN-H)
Step 6
Slide the slave fan tray until the snap lock clicks in to place and the fan tray is seated completely.
Step 7
Repeat steps 4 and 5 for the second slave fan tray.
This completes the procedure for installing the fan trays in a Cisco NCS 560-4 Router.
For a summary of the LEDs on the fan tray, see the Pinout and LED Details section. For more information
about air flow guidelines, see the Air Flow Guidelines section.
Removing and Replacing the Dust Filter
The chassis is shipped with two blank fan filter covers with the same product identifier (N560-4-FILTER).
To install the dust filter:
Before you begin
If the cables from the interface modules on the right of the chassis cross over the dust filters, gently lift the
cables to clear enough space to remove the dust filters from the chassis.
Removing and Replacing the Dust Filter
Cisco NCS 560-4 Router Hardware Installation Guide
79
Hide quick links:
Advertisement
Table of Contents
